Reflectors Effect on Increasing the Output Power of Reflex Triode

Document Type : Original Article

Authors

Abstract

The reflex triode is one of the varieties of vircators that areamong several types of high power microwave sources. The Main application of these tubes is the disruption of enemy systems by creating a strong electromagnetic field on the target. This paper presents a comparison of experimental and simulation results of a reflex triode.Experimental and simulation results are in good agreement. The software used for simulationis the CST STUDIO SUITE. It is based on the Finite Integration Technique (FIT) and includes a particle in cell code. In previous studies, with the use of two disk-shaped and strip reflectors in this tube, the electric field output was increased by a maximum of 126%. In this research for the first time with the introduction and use of wall reflector, the electric field output was increased by 193%. It was shown that each of the disk-shaped, strip, and wall reflectors increased 37% and 29% of the output electric field, respectively.A variation in the position of the reflector causes a variation in the radiation power. This variation is periodic.

Keywords

References

[1]     Barker, R. J.; Schemnoglu, E. “High-Power Microwave Sources and Technologies”; IEEE Press, 2001.##
[2]     Mardani Shahrebabak, M.; Kamyab Sharif, M. “Construction of Conductivity Concrete as Modern Material in Electromagnetic Shielding”; Adv. Defence Sci. Technol. 2014, 5, 211-217. (in Persian)##
[3]     Benford, J.; Swegle, J. A.; Schamiloglu, E. “High Power Microwaves”; CRC Press, 2015.##
[4]     Benford, J.; Price, D.; Sze, H.; Bromley, D. “Interaction of a Vircator Microwave Generator with an Enclosing Resonant Cavity”; J. Appl. Phys. 1987, 61, 2098-2100.##
[5]     Santos, A. L.; Araujo Filho, B. S.; Barroso, J. J.; Maciel, H. S. “Microwave Generation by a Virtual Cathode Enclosed in a Circular Cavity Placed Transversally in a Cylindrical Waveguide”; IEEE Int. Vacuum Electronics Conf. 2008, 45, 368-369.##
[6]     Bromborsky, A.; Agee, F.; Bollen, M. “On the Path to a Terawatt: High Power Microwave Experiments at Aurora”; Proc. Microwave and Particle Beam Sources and Propagation 1988, 51 , 873-877.##
[7]     Liu, L.; Li, L. M.; Zhang, X. P. “Efficiency Enhancement of Reflex Triode Virtual Cathode Oscillator Using Carbon Fiber Cathode”; IEEE Trans. Plasma Sci. 2007, 35, 361-365.##
[8]     Clements, K.R.; Curry, R.; Druce, R.; Carter, W.; Kovac, M.; Benford, J. “Design and Operation of a Dual Vircator HPM Source”; IEEE Trans. Dielectr. Electr. Insul. 2013, 20, 1085-1090.##
[9]     Moller, C.; Elfsberg, M.; Larsson, A.; Nyholm, S. E. “Experimental Studies of the Influence of a Resonance Cavity in an Axial Vircator”; IEEE Trans. Plasma Sci. 2010, 38 , 1318-1324.##
[10]  Razavi, S. M. J.; Shafieikhah, N.; Razavi, S. M. “A Novel Method for Improving the Efficiency of a Reflex Triode Tube in a Dominant Mode”; Adv. Defence Sci. Technol. 2019, 2, 33-37. (in Persian)##
[11]  Champeaux, S.; Gouard, P.; Cousin, R.; Larour, J. “3-D PIC Numerical Investigations of a Novel Concept of Multistage Axial Vircator for Enhanced Microwave Generation”; IEEE Trans. Plasma Sci. 2015, 43, 3841-3855.##
[12]  Chen, Y.; Mankowski, J.; Walter, J.; Kristiansen, M.; Gale, R. “Cathode and Anode Optimization in a Virtual Cathode Oscillator”; IEEE Trans. Dielectr. Electr. Insul. 2007, 14, 1037–1044.##
[13]  Zherlitsyn, A. G.; Mel’nikov, G. V.; Ya Isakov, P. “Effect of Feedback on the Microwave Radiation in a Triode with a Virtual Cathode”; J. Commun. Technol. Elec. 2007,  52, 798–802.##
[14]  Parson, J. M.; Lynn, C. F; Mankowski, J. J.; Barnett, D. H. “Frequency Stable Vacuum-Sealed Tube High-Power Microwave Vircator Operated at 500 Hz”; IEEE Trans. Electron Dev. Lett. 2015, 36, 508-511.##
[15]  Chen, Y. J.; Neuber, A. A.; Mankowski, J. J.; Kristiansen, M. “Design and Optimization of a Compact,  Repetitive HPM System”; Rev. Sci. Instrum. 2005, 76, 104-107.##
[16]  Baryshevsky, V.; Gurinovich, A.; Gurnevich, E.; Molchanov, P. “Experimental Study of a Triode Reflex Geometry Vircator”; IEEE Trans. Plasma Sci. 2017, 45,  631-635.##
[17]  Jiang, W.; Shimada, N.; Prasad, S. D.; Yatsui, K. “Experimental and Simulation Studies of  New Configuration of Virtual Cathode Oscillator”; IEEE Trans. Plasma Sci. 2004, 32 , 54–59.##
[18]  Roy, A.; Menon, R.; Sharma, V.; Patel, A.; Sharma, A.; Chakravarthy, D. “Features of 200 kv, 300 ns Reflex Triode Vircator Operation for Different Explosive Emission Cathodes”; Laser Part. Beams 2013, 31 , 45-54.##
[19]  Rocha, E.; Kelly, P. M.; Parson, J. M. “Evaluating the Performance of a Carbon-Epoxy Capillary Cathode and Carbon Fiber Cathode in a Sealed-Tube VircatorUnder UHV Conditions”; IEEE Trans. Plasma Sci. 2015, 43 ,45-51.##
[20]  Karlsson, M.; Olsson, F.; FilipsSon, G.; Edbom, E. “Comparision Between Experimental and Numerical Studies of a Reflex Triode”; IEEE Int. Pulsed Power Conf. 2005, 86, 210-213.##
[21]  Neuber, A.; Hemmert, D.; Krompholz, H.; Hatfield, L.; Kristiansen, M. “Initiation of High Power Microwave Dielectric Interface Breakdown”; J. Appl. Phys. 1999, 86, 1724-1728.##
[22]  Morales, K. P.; Krile, J. T.; Neuber, A. A.; Krompholz, H. G. “Pulsed Dielectric Surface Flashover in Atmospheric Conditions”; IEEE Trans. Dielectr. Electr. Insul. 2006, 13, 802-809.##
[23]  Saxena, A.; Roy, A.; Kanakgiri, K. V.; Petkar, S. J.; Kazi, F. S.; Singh, N. M. “Modeling of  Reflex Triode Virtual Cathode Oscillator”; IEEE Trans. Plasma Sci. 2016, 44, 2399-2405.##

Files

History

  • Receive Date: 10 January 2019
  • Revise Date: 06 May 2019
  • Accept Date: 02 June 2020
  • Publish Date: 21 May 2020

Share

How to cite

Statistics